High-frequency wave plastic welding machine Cautions

1. This machine must be installed on the ground (connected to the correct ground);

2. Machine, moisture, dust is extremely sensitive to be placed in the appropriate space;

3. Of the vacuum tube of the machine will produce high fever, so we can not be placed next to the produce heat machine, can not be installed in the solar direct exposure to the reasons mentioned above will affect the cooling function of the vacuum tube;

4. Machine downtime over one hour, re-boot, need to wait 10-15 minutes for the vacuum tube warm-up to protect the life of the vacuum tube;

5. The upper and lower extremes of the machine (up and down mode) is not met, and between, in its necessary insulation and work pieces;

6. Operation, when the high-frequency output, remember to not touch on the output side (ie, the upper die), also no longer universal table, test the meter or other low-frequency, low voltage instrumentation, trying to direct measurement of the output side, this will cause of the accident;

7. Periodic inspection under the extreme (mode) of the insulation, if you are damaged, burned, breakdown, you need to immediately replace the insulation, or if they continue to work to produce sparks, unable to complete the process;

8. If you often spark phenomenon occurs (in the upper and lower mold touched each other, high cycle output) rather than to check the maintenance will lead to machine parts damaged, affecting their work;

9. Work material used to make the finished product, try to not have water, dust, easily lead to sparks generated due to the above objects;

10. Machine power is turned on, will hear the sound of the fan rotation (4KW 5KW's voice has been weak), this vacuum cooling, if the fan fails, it must immediately repair, or will result in the vacuum tube damage.